Logo

P386C Engine Trouble Code

Meaning of P386C engine trouble code is a kind of powertrain trouble code and P386C if your catalytic convertor fails completely, you eventually won't be able to keep the car running. Your gas mileage will also be terrible, so you should try and fix it as soon as you can. Unfortunately, the average replacement cost is around $2,140 and you can't do it yourself unless you're an experienced mechanic.

P386C Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P386C code is occuring now you should check P386C repair processes.
Now don't ask yourself; What should you do with P386C code ?
The solution is here :

P386C Possible Solution:

P386C Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

P386C Code Meaning :

P 3 8 6 c
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Ignition System Or Misfire Engine Oil Temperature Sensor Malfunction Cylinder 4 Contribution/Balance Fault

The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate.

P386C OBD-II Diagnostic Powertrain (P) Trouble Code Description

P386C engine trouble code is about .

Main reason For P386C Code

The reason of P386C OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

P386C DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.